SteveW
Elder Statesman
Posts: 1,395
|
Post by SteveW on May 13, 2007 19:55:20 GMT
Guys,
I pushed the boat out again and bought a set of six 0.5 mod involute gear cutters from Chronos the other day to complete another on-going project. Problem is these only go from 12 to 54 teeth which is barely 1:4.
The current set are for a 16mm arbor but I'd like to get the other two some how to complete the set but they're not shown in the catalogue.
1. Does any one know where I can get the next two in the series (55-134 and 135 - rack)?
2. How much does it matter if I use the 34-54 cutter up around 60-100 for a low speed intermittent application?
|
|
|
Post by Tel on May 14, 2007 9:40:11 GMT
|
|
|
Post by havoc on May 14, 2007 17:39:20 GMT
|
|