|
Post by havoc on May 15, 2007 18:09:58 GMT
After trying to cut off a piece of steel I found that there was more play on my lathe than I found admissible. So I tought of adjusting this using the gibs. I just turn the bolts till I found eveything rathern snug without being too hard to move and blocked it at that setting. But now I wonder...
What is the correct procedure to adjust those things?
|
|
|
Post by chameleonrob on May 15, 2007 19:55:38 GMT
just turn the bolts till you find everything rather snug without being too hard to move and blocked it at that setting. Ideally it should feel silky smooth when moved, my old lathe could never be set like that as two turns of the hand wheel moved the saddle 2 1/2 feet but the principle is the same
|
|