|
D1-3
May 19, 2007 17:25:26 GMT
Post by 3405jimmy on May 19, 2007 17:25:26 GMT
D1-3
All the chucks I have are D1-3 camlock fitting. You can buy back plates anywhere but I would like to buy a nose, the same as you find on the lathe. So I can make up an adapter for the rotary table any ideas?
Jim
|
|
|
D1-3
May 19, 2007 21:48:53 GMT
Post by GWRdriver on May 19, 2007 21:48:53 GMT
My guess would be that your best chance of finding a nose would be the spindle off a machine headed for a skip, if you could find such a machine, but then my guess would also be that it would be hardened.
I would consider turning a nose from a piece of BMS and purchasing the cams as spares. I have done the reverse; I've made several D1-3 backplates and purchased the studs as spares from Bison.
|
|