Post by peteh on Sept 13, 2017 11:14:58 GMT
Hi folks,
Part way through my 10V build and started looking at the reversing gear. In the attached jpg you can see how Stuart intend to join (pin) the eccentrics at 120 degrees. Unfortunately there appears to be an error in the drawings.
The original eccentric is shown as having the pin hole offset 60 degrees from the disc centre whilst the additional eccentric is shown with the pin hole offset from the shaft centre. Obviously there will not be 120 degrees between then. I can only assume that the pin hole should be from the shaft centre on each eccentric
Part way through my 10V build and started looking at the reversing gear. In the attached jpg you can see how Stuart intend to join (pin) the eccentrics at 120 degrees. Unfortunately there appears to be an error in the drawings.
The original eccentric is shown as having the pin hole offset 60 degrees from the disc centre whilst the additional eccentric is shown with the pin hole offset from the shaft centre. Obviously there will not be 120 degrees between then. I can only assume that the pin hole should be from the shaft centre on each eccentric