gwr
Involved Member
Posts: 56
|
Post by gwr on Jan 8, 2018 0:36:43 GMT
I have a Denford easimill 3 that I would like to upgrade to a current upto date operating system. Does anyone have any upgrade advice, or systems they have upgraded. Thanks
|
|
|
|
Post by Doug on Jan 10, 2018 10:09:20 GMT
Depending on what you have to spend will guide your decision, an easy update would be to use Mach3 or the newer Mach4 the former now headed for “no longer supported” status the logical choice would be Mach4 all your hardware should be ok you will just need an interface, for that you’re best going for the best you can afford. I am currently running Mach3 and don’t have any experience with Mach4 integration so can’t advise much on that but I would expect that it is very similar to Mach3. If you are looking to keep the costs down then Mach3 is still a very good option as it is super cheap and very easy to setup with lots of utube vids to help.
|
|
|
|
Post by Roger on May 4, 2018 21:39:01 GMT
I didn't want to hijack your thread so I started my own specific one about upgrading from Mach3 to Mach4
|
|
