|
|
Post by wozzoiom on Nov 6, 2021 12:40:03 GMT
Hi .i have just bought a Winson kit of the L&Y 5" gauge pug 0-4-0ST.and there was no instructions with it .after talking and buying the manual from engineers emporium I now find there is a section missing from that manual .it is the instructions for I believe kit 6.thats the pipe work diagram and fitting instructions .
would there be anyone on this forum that could help me source the missing kit diagram and information .
thanks in advance if you can help .
warren
|
|
|
|
Post by wozzoiom on Nov 9, 2021 23:32:00 GMT
62views and no reply’s ,surely someone must have a copy of the instructions?
|
|
|
|
Post by cplmickey on Nov 10, 2021 19:25:03 GMT
I can't help unfortunately but I would be very annoyed at buying the manual from Engineers Emporium and finding a missing section. That's hardly "fit for purpose" is it. Are they not able to help further? It's not a loco I've seen around so I'm guessing Winsons didn't sell many, hence the lack of replies. Ian
|
|
|
|
Post by wozzoiom on Nov 10, 2021 22:43:47 GMT
I contacted engineers emporium to ask about the missing sections of the book and they replied “that’s all the information we have “
at £40 for the book that wasn’t the answer I was expecting.its not as tough I can send it back as I do need it to complete the train .
|
|
marcf
Hi-poster
Posts: 170
|
Post by marcf on Apr 22, 2023 5:50:23 GMT
I have a set coming if you need a copy still
|
|
Kevan
Seasoned Member
Posts: 138 
|
Post by Kevan on Nov 19, 2023 16:06:40 GMT
Hi, I have just bought a Winson pug that needs some significant work . Does anyone have a source if drawings/ building instructions so I can do something about reworking the one I now have?
|
|
oldnorton
Statesman
5" gauge LMS enthusiast
Posts: 720
|
Post by oldnorton on Nov 20, 2023 9:33:28 GMT
I can comment from what I have seen of the Modelworks Britannia document set. The manual shows a builder how to put together the set of parts delivered but there are few dimensions or drawings in the conventional sense. I certainly never referred to that document.
I assume that most other Modelworks manuals are the same. Their Britannia was based on the Perrier Britannia drawings, with most all dimensions being the same and the addition of some castings and the change of all screws to metric sizes. I would suspect that all Modelworks engines are based on previous designs with the same production changes.
Your best bet is to find what the original drawing set for the L&Y Pug was (I don't know) and buy a set of those. Then you can rebuild/restore it to the condition that the original designer intended.
|
|
