Need help with large dia alu ring

[michael]

Hi All

I have a Dnepr gearbox that I need to mate to a BMW engine (I'm putting a BMW engine in my Dnepr MT11 outfit).

In order to have the gearbox input shaft line up properly in the clutch I need an adapter ring. This must be app. 235mm outside diameter and 230mm inside diameter. Probably 5mm thick. I don't have the exact measurements yet but will take them off the engine and gearbox.

My lathe and mill are too small for a job like this. Can anyone point me in the direction of a business that will do a one-off job like this?

Michael

[steammadman]

michael
If you would like to send me your email adress iwill send you
a copy of an adapter to fi on your lathe which will allow you to
machine your attachment with not too much work,and you can use
it over and over again.I will remain here on line for the next hour or so

[michael]

My email is: michael(at)mbhh.co.uk

[steammadman]

I have sent you an email with attachment
should be with you any minute now.

steammadman