paul
Member
Posts: 8
|
50-50
May 26, 2007 17:30:12 GMT
Post by paul on May 26, 2007 17:30:12 GMT
This is the (almost finished) con-rod for my small all-fabricated engine. This part was turned to approximate size from 19mm steel rod then the taper machined. The fork is all file work (except for the hole of course!) and as a consequence has taken flippin' ages!!  (50% by machine 50% by hand, 100% made by me from scratch) |
|
|
|
50-50
May 27, 2007 9:50:33 GMT
Post by Tel on May 27, 2007 9:50:33 GMT
..... and as a consequence has taken flippin' ages!! (50% by machine 50% by hand, 100% made by me from scratch) But the result is well worth it - nice. |
|
|
|
50-50
May 28, 2007 10:01:02 GMT
Post by Shawki Shlemon on May 28, 2007 10:01:02 GMT
That is modeling ,well done .
|
|
paul
Member
Posts: 8
|
50-50
May 28, 2007 15:21:18 GMT
Post by paul on May 28, 2007 15:21:18 GMT
Thanks gents!
|
|
abby
Statesman
Posts: 927
|
50-50
Jun 12, 2007 20:15:26 GMT
Post by abby on Jun 12, 2007 20:15:26 GMT
Nothing looks as good or gives as much satisfaction as a job well filed I reckon.
Abby.
|
|
